Home Repair Tips & Tricks



It’s not easy to get repairs done in your home, especially if you have no idea where to start. To make things easier for you, below are some tips and tricks from an expert handyman services Colorado Springs that can help you get your repairs done on time and without ruining your budget.

Cut Crown Molding

There may be some cases where you need to modify or cut crown molding at home. To do this, begin by placing the molding at the miter saw fence. The molding should be at the same angle with the area where it’s going to be installed. However, you need to turn it upside down. That way, the ceiling edge will be at the base part of the miter saw while the wall edge rests at the fence of the saw. While in this position, gently cope the inside corners of the molding.

Silent the Screen Door

It can be annoying to hear the loud bang of a screen door each time someone closes it. If your door is doing this, apply short beads of silicone caulk at the jamb area, as well as in some areas at the contact points. This can help soften up the blow and prevent any loud bangs each time you close the door. Just make sure to prop the door open for about a couple of hours after the caulk is applied so that the silicone caulk can dry completely.

Fix Rotting Fence Posts

If you have noticed that the posts on your fence are starting to rot, then you need to immediately fix them. An expert Colorado Springs handyman would recommend that you simply pull the wooden post off its concrete foundation. Fix a new post to replace the rotten one you have removed and then trim the top flush so they will have the same height with the other posts.

Store Open Paint

If you have some leftover paint, the best way to store it is in a glass jar. The jars are less likely to make the paint dry. Opt for the transparent jar so you can easily see the color of the paint that you stored in it. To make sure that the paint will not seal the lid of the jar, run a Teflon tape around the edge of the jar before you put its lid on.

Clean Belt Sanders

If you have a clogged belt sander, clean it with the sole of a shoe. Clamp the sander upside down, turn it on, and gradually apply the sole of a shoe against the belt. You will soon notice it will clean right up and the clog will be fixed.

Installing Wood Floor Molding

If you need to install wooden floor molding at home, all of the outside corners of the molding can be cut at an angle of 45 degrees. However, the entire inside corners should be coped. Coping can best be done by hand.

With these home repair tips and tricks in mind, you no longer need to hire a professional handyman Colorado Springs just to get some of these home repairs done.