The best way to Transfer Shower Conduits into a Tub Wall



In the event that you would like to retrofit a bath- setup that is only to supply a shower at home, the most easy method would be to change out your bath spout. It’s possible for you to put in another kind of spout that includes an adaptor, letting you mount a shower hose that is flexible . To completely include shower pipes on the other side of the tub wall is a task that is demanding, for those who are in possession of a fundamental foundation in Plumbing Boston repair specialists, but one you’ll be able to do completely in your own.

Shut off the primary water valve to your house. Until water stops emptying from it open the kitchen faucet.

Unscrew the screws holding the bathtub faucet handles. Pull off or unscrew the escutcheon plates. Loosen the setscrew, if existing, keeping the bathtub then unscrew or display the spout and spout set up.

Reach your work space behind the present wall of the bath — the wall including water-supply lines and the bath spout. Pry tiles in the edge of the tub up to the location of the shower arm, and from stud flanking the faucet off. Cut gypsum board or the backer board using a drywall saw or device respectively.

Cut the present cold and hot water supplies in order to take away the bath- a CPVC and faucet, utilizing a copper tube cutter for copper conduits. Replace having a bath- faucet, utilizing conventional copper- fittings or perspiring methods for copper conduits or CPVC primer and cement for CPVC pipes.

Cut on a 2-by- 6 brace on a chop saw to fit snugly between the studs in the peak of the shower head, both 48-inches over the rim of the bathtub or large enough for the member of your family. Screw or toe-nail the brace in to place. Twist a fall-ear elbow supported by means of a conduit strap to the middle of the brace. Cut at a shower line by means of your tube cutter to to match in the faucet up to the fall- ear. Join the line -sweating methods or fittings for copper conduits, or CPVC primer and cement for CPVC pipes.

The faucet handles and connect and tub spout and caps and nipples together. Turn on the faucets as well as the key water valve to test for leaks. Address of weeping before the pipes connections, any negligible signs are completely dry by tightening or changing, subsequently testing, the connections.

Turn off the water in the principal valve until no mo Re water is in the conduits, and operate the kitchen faucet. Take away the faucet handles, shower head and tub spout. Reconstruct your “ wall that is wet with water-resistant or board dry wall, reducing openings for the conduits. Tile or end the wall and re install your taps, escutcheons and shower head.

See related