How to Remove a Wheel From a Rear Axle in an MTD Lawn Mower



The wheels on your own MTD lawn in Salt Lake City mower are secured to axles with removable hardware. Whether you’ve got a apartment or you need to grease an axle, the way you go about removing a wheel in a rear axle of a MTD lawn in Salt Lake City mower varies slightly depending on whether yours is a lawn in Salt Lake City mower, a push mower or a self-propelled mower.

Riding Mowers

Remove the key in the ignition and then engage the parking brake to stop the mower from moving.

Elevate the rear end of the mower by means of a jack until the rear wheels are clear of the Landscaping design San Diego.

Place jack stands under the rear end of the mower, then lower the jack until the mower is sitting securely on the stands. To reduce injury, never work around or beneath an elevated riding mower without supporting it with jack stands.

Eliminate the hub cap, then if one is present. To do so, slide a flat screwdriver round the rim and then gently pry off the cap.

Loosen and then remove the hardware securing the wheel set up. The type of hardware will vary based on model. Must versions utilize conventional half-inch nuts. Maintain the nuts in a safe place, as you may need them if you opt to reattach the wheel later.

Slide the wheel off the axle.

Push Mowers and Self-Propelled Mowers

Disconnect the spark plug wire from the engine. The exact location and alignment of the wire will vary slightly based on the MTD model you are using. Consult with the mower’s manual for more information.

Adjust the deck height in order to give your hands sufficient access to the rear wheels. Skip this step if your mower doesn’t have adjustable deck heights.

Connect a socket wrench into the bolt at the middle of the wheel you want to remove, then twist the wrench counterclockwise to loosen and remove the nut.

Slide the wheel off the axle.