How To Rekey A Door Lock In 4 Steps

From time to time, you may find yourself in a situation where you cannot access your home because of a problem with the locks. One of the options is to consider getting an expert to rekey the lock. There are many electrician Phoenix AZ who can assist you with this. You will, however, need to make sure that you are hiring a professional.

Lock rekey is basically about changing the pins and removing the lock cylinder. It might sound very simple, but it’s not necessarily the case. You can also learn a few tips that will help you get through this like a professional. It will cost you nothing but a small fraction of what an expert would charge you, and all you need is a good rekeying kit. This way, you do not have to call a Phoenix electrician when you can do it on your own.

How much will it cost you? Less than $20!

Most of the popular lock brands have rekey kits available in different stores. However, these are not interchangeable. It will be a good idea to buy a rekey kit for every lock brand that you have in your home. The following are some tips on how to do it right once you have the kit:

Removing The Knob

Use the wire tool in your kit and insert it inside the knob hole. This should allow you to depress the knob clip and remove the knob from your door. Turn the key inside your lock until the door is completely unlocked.

Removing The Retainer Ring

To pop off the cylinder, insert and push the retainer ring tool against it. This should force the retainer ring off. Put it aside and make sure you don’t lose it because you will have to replace it later on.

Removing The Cylinder Plug

Insert the key you have been using and turn it either side. This action should remove the plug because it pushes the plug follower all the way through the cylinder. While you do this, maintain sufficient pressure so that the springs and pins do not fall out. In case they fall out, follow the simple instructions in the manual on how to reinsert them.

Colored Pins And Color Code

Remove the old pins and insert the new key. With a small needle nose pliers or tweezers, make sure the colored pins are matched with the color code indicated on your instruction sheet. As soon as all the pins have been inserted properly inside the cylinder, you can then repeat the steps above in reverse, to reassemble your lock.

Tools You Will Need

In order for you to effectively carry out electrician Phoenix, you will need the following set of tools:

-Screwdriver (4 in 1)
-Needle nose pliers
-Any special tools that are available in your kit

The rekey kits are affordable, and with a complete set, you should be able to rekey up to 6 locks. All this is possible at a fraction of what you would have to spend on hiring an expert. However, in case you find this procedure to be very complex, there’s nothing wrong with getting in touch with professionals to assist you. It’s way better to hire someone than to damage your locks in the process.