Honda Mower Chokes Out Once Engaging Blades



If your Honda mower fires up quickly and easily but stick out the moment you engage the blades, it can be a troublesome experience. Instead of giving into frustration, then give the mower a once-over to see what the problem is. Whatever from operator error into minor malfunctions to mechanical problems could possibly be the cause of the engine that dies when you engage the blades.

Honda Mower Blade Operation

Several Honda mowers have a separate control for engaging the blades. On these models, although the motor is running, the blades remain stationary until you take particular steps to start them. To prevent engine stalling problems, push on the blade release button, typically situated on the cover of the blade control lever. With the button depressed, push the lever forward and hold it against the handlebar prior to removing your finger from the button. Loosening your grip on the controller lever slightly can cause the motor to stall. When the blade control lever is released, then the blades will cease and the motor will keep on running.

Clogged Mower Deck

Something as straightforward as a clogged mower deck can impede the improvement of the blades and make the mower to stall. Clean the underside of the deck after each use of this mower to make sure it remains clear of debris. Cut Grass Care service Phoenix, AZ can harden, solidify and attach to the blades and deck when left to dry. With the fuel valve switched off and the spark plug disconnected, then turn the mower on the side and bend down the underside of the deck. Avoid wetting the controls, cables and air filter.

Throttle Settings

Honda advises users to mow their lawns using the throttle set on the highest setting. Utilizing a lower setting might not supply enough power for the job, causing the mower to stall out when you engage the blades. Once you’ve started the motor, move the throttle lever to the highest setting and keep it there while you engage the blades and mow the yard. Should you block the mower at any stage, don’t forget to set the throttle to the highest setting again when you restart the mower.

Lawn Care estimate Phoenix, AZ Height and Thickness

Mowing Lawn Care near me Bakersfield, CA that’s particularly thick or tall can cause the blades to slow and the motor to stall, particularly if the throttle isn’t set to the highest setting or if the deck is adjusted too low. Always start the mower on a level surface that’s obstacle free and then engage the blades prior to moving the mower in to tall, thick Lawn Care price Littleton. Adjust the cutting height of the mower to the highest setting and produce an initial pass over the area. Stop the mower, lower the cutting height and mow the Lawn Care service Littleton, CO on that atmosphere. Avoid letting the Grass Care near me Littleton to reach such heights that might cause the mower to stall.

Engine, Gas and Filter Issues

Bad fuel or an empty fuel tank can also cause your Honda mower to stall when beginning and engaging the blades. Make sure there is gas from the gas tank prior to beginning. If the mower hasn’t been operated in a number of months and gas stayed in the tank, the fuel might be awful. Replace the old fuel with fresh gas. Clogged fuel filters, carburetor and ignition malfunctions and stuck valves can also result in stalling. Should you ruled out basic causes such as bad fuel and washed the deck along with the mower chokes out, Honda advises taking the mower to an authorized service center and get it serviced.