For suitable chain saw operation, it is essential to provide adequate lubrication to this chain in the form of oil. Husqvarna chain saws possess an automatic oiler that always pumps small amounts of oil in the reservoir through the attached oil, and onto the saw’s guide bar and chain. When the line is clogged, however, the oil can’t get to the chain, placing you and your equipment at risk.

Symptoms of a Clogged Line

The first clue that the oil line about the Husqvarna chain saw might be clogged is when there’s little to no adhesive on the chain. The chain can run heavier than normal without the essential oil to cool it. Indicators of a hot chain include smoking through cutting and discoloration of the guide bar. Cutting is more difficult with a dry chain and you may observe that the chain saw should be forced through the timber rather than slicing through it cleanly.

Reasons for Clogs

Clogs can occur in the oil line that contributes to the oil pump to the guide bar and chain for a few reasons. Storing the Husqvarna chain saw without cleaning the oil station and groove in the guide bar and the chain before storage, particularly long-term, can cause the oil to harden and shake at the point at which the oil leaves the line. If the bar tip sprocket is unable to turn smoothly, the hole that emits the oil might become clogged, thereby clogging the line also.

Avoiding Clogs

Preventing oil line clogs from happening in the first place is that the smartest move any chain saw operator may create. Make sure that you use the suggested type of oil for your chain saw. Husqvarna recommends using their vegetable-based oil for the best outcomes. In the lack of Husqvarna chain saw oil, then utilize conventional chain saw oil as opposed to different kinds of lubricant. Clean the guide bar station and groove regularly to stop old oil in thickening, hardening and clogging the device.

Clog Repair

When you’ve realized that the chain isn’t receiving a sufficient amount of oil, clean and lubricate the bar tip sprocket to find out if that solves the problem. If necessary, remove the fuel line in the chain saw and then soak it in warm water to loosen any clogs. Blow through one end of the tube to find out whether the air clears the tube and forces out any clogs. You are also able to straighten a thin cable hanger and guide it gently through the oil line to clear clogs. With a pipe cleaner dipped in oil solvent is another option. When all else fails, replace the fuel line with a brand new one.