The electrical wiring system at home is designed to deliver power to every room where it’s needed. A well-functioning wiring system is required if this objective will be achieved. However, writing systems tend to run into problems every now and then.

Here are a few solutions to some of the common electrician Chandler AZ wiring problems at home:

Overlamping

Overlamping is a situation where the bulb attached to a light fixture has a higher wattage than required.  This creates a strain on the wiring system. To solve this, always pay attention to the bulbs you attach to every fixture. They need to match the capacity of the fixture they are installed to.

Uncovered Junction Boxes

Junction boxes need to be covered all the time to avoid tripping the wires or electric shock. The junction box covers come off as they get old. Just buy new ones from your local hardware store and have them installed.

Flickering Lights When It’s Windy

This problem is often caused by a short circuit when the overhead electricity cables supplying power to your home come into contact. This is not something you can fix. If the problem persists, contact the electricity company and notify them.

Not Enough Outlets

Homes that lack enough outlets will often rely on extension cords to supply the power to various appliances. Extension cords are not a good solution and may pose dangers to you and the appliances they are connected to. The solution to this is to add new outlets. First floor outlets will cost $100 each to install while second-floor outlets will cost double the amount.

No GFCIs

Lack of GFCIs increases the risk of electrocution in wet areas including the kitchen and the Designer Bathroom Concepts Pittsburgh. This is a very big danger and you cannot afford to live with it. A possible solution would be to replace the old receptacles with GFCIs. The GFCIs will cost $12 each and you can install them yourself.

Aluminum Wiring

Aluminum wiring was mostly used in the early 1960s and 70s. A lot has changed in electrician Chandler wiring since then. Copper is considered a safer and more efficient option. To fix this issue, you will need to overhaul the entire wiring systems and replace the aluminum with copper.

Ungrounded Receptacles

Grounding the receptacles is designed to safely conduct stray current that somehow manages to escape from the main wires. Although this is not something serious, you can never take a chance with electricity. To fix things, you will need to replace the two-prong receptacles with a three-prong one.

Backstabbed Wires

This is a situation that arises when the wires pushed back behind the switches become loose. The best way to deal with this is to unscrew the switch from the wall and put the wires back in place. Attach the switch back as tightly as possible. Make sure that the main switch is switched off before you start this.

The common Chandler electrician issues above can be fixed with simple DIY solutions. The simple suggestions above should help you get the job done.